Recently Updated

Center To Center Distance Between Bolt Holes Along Width and Length 1.25" Outside Edge To Bolt Hole Center Distance Along Width and Length 0.187-0.202"

left flange width 0.1 right flange width 0.1 solid external flanges both ends

gaging member outside diameter tolerance +0 to 0.0005 inches

steel material

thread length 0.293-0.31" head diameter 0.357" head height 0.182-0.188" hexagon internal drive

depth 18.5" width 20.75" frequency rating 50-60 hertz

length: 35.9 to 36.1 width: 1 inch strap

Distance From Aperture Center To Mounting Hole Center 0.495-0.505" Center To Center Distance Between Mounting Holes Along Length 0.998-1.002" temp rating 900 degree fahrenheit

rubber material sectional height cross 0.069-0.075

length: 0.42 diameter: 0.35 steel

Length: 0.35 diameter: 0.438 anodized finish

usage location Conus component quantity 3 Test set and repair shop equipment

copper material sleeve nut nut diameter 0.432-0.436" nut length 0.26"

length 0.72-0.73" thread length 0.305-0.41" steel material, distance from centerline to flat 0.205-0.215"

Consists of connector tube part no. a8720 and adapter tube partno. a8722 used on leg assy front part no. a8597-10 hh-1h acft

Used as a gearbox drive bevel gear shaft base during engine component repair for F100 Pratt & Whitney engines

Length: 0.75 thread length: 0.187 aluminum alloy 5365000011292.

length 4.38" width 2.75" Equipped with read out meter with special tip mounted on sensor

End Item Identification hh-1h Bell Helicopter

plastic material One 0.469 in. diameter hole in center 0.297 in. by 0.984 in c to c two 0.437 in. diameter holes spaced 2.842 in. by 0.984 in c to c