Special Features:

1first end has two additional, ident, thd holes, all thd holes are equally spaced on a 1.500 in. Bolt circle ida; scond end partial bore, 0.340 in. Dia, 2.250 in. Dp; second edn int thd, 0.850 in. Lg; second end counterbored, 1.120 in. Dia, 0.500 in. Dp

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.